jakerupert Posted September 25, 2010 Share Posted September 25, 2010 Let`s say you have applied a decal to some patches and lateron you have changed the patches and added some cps. Do you have to apply the decals a new always in any case or is there a possibility to include the cps into the existing stamp afterwards so that the whole decal is showing up again? Quote Link to comment Share on other sites More sharing options...
TheSpleen Posted September 25, 2010 Share Posted September 25, 2010 I am no expert but I would just reapply it. Quote Link to comment Share on other sites More sharing options...
Paul Forwood Posted September 25, 2010 Share Posted September 25, 2010 Unfortunately you do have to reapply your decals if you add any new splines. The flattening gets messed up too. Quote Link to comment Share on other sites More sharing options...
Fuchur Posted September 25, 2010 Share Posted September 25, 2010 Unfortunately you do have to reapply your decals if you add any new splines. The flattening gets messed up too. You will have to reapply, BUT you can use "Recall Position" to apply.. that should make it much easier... -> Rightclick on the stamp and choose "Recall Position". Than apply the decal again... Flattening should be done in an Action and I use groups (without any surface-properties etc.) to save the parts I need to reapply the stamps too. *Fuchur* Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.