hooks

[Master chief]

ok i remember in times past that you could manipulate the bias of a spline with a hook , currently i cant figure out how to do this again any one know

[robcat2075]

no, you can't change the bias of a hook.

[Master chief]

ok maybe i didnt explian what it would do , you know how you cant change the direction the spline is going through by changing the bias , well back a few verison u used to be able to ues a line connected to the point to change that manualy i though it was called a hook

[Caroline]

To change the bias of a spline, click this button at the top.

 

 

When you click on a spline near the control point, that will show the bias manipulators, which you can change.

 

 

(I hope that was what you are after )

[GAngus]

Just so we are all on the same page here, from the Tech manual,

 

"The control point that will form a hook is attached to the center of a spline just as it would be attached to another control point. Hold the control point to be hooked over the center of a spline, and with the left mouse button down, right-click (on a Mac, press the key on the keyboard, called a tilde)."

 

So, dragging a CP over to the middle of another spline and doing a right-click will produce a "Hook".

 

 

To change the bias of a spline, click this button at the top.

 

 

When you click on a spline near the control point, that will show the bias manipulators, which you can change.

 

 

(I hope that was what you are after )