mtpeak2 Posted February 13, 2005 Share Posted February 13, 2005 Is this what you want? Quote Link to comment Share on other sites More sharing options...
mtpeak2 Posted February 13, 2005 Author Share Posted February 13, 2005 Here's the material, if it is. I changed the octaves and grid size for the stripe thickness. Quote Link to comment Share on other sites More sharing options...
steve392 Posted February 13, 2005 Share Posted February 13, 2005 Now thats a nice matt ,thank's a lot for putting this up I have learned something , again Quote Link to comment Share on other sites More sharing options...
heyvern Posted February 13, 2005 Share Posted February 13, 2005 That's it baby! WooHoo! Thanks much kind sir. Let you know how it goes... Vernon "!" Zehr Quote Link to comment Share on other sites More sharing options...
johnl3d Posted February 14, 2005 Share Posted February 14, 2005 i always made stripes with the checker set up ...just zero out the appropriate value to make the stripes Quote Link to comment Share on other sites More sharing options...
heyvern Posted February 14, 2005 Share Posted February 14, 2005 I tried that John... no luck. No matter what I did I could not get the vertical lines consistent around the sides of a cylinder. Very ugly results. I think that technique works better with flat shapes. I could get horizontal "rings" no problem. The gridturb was perfect. It will be used in my image entry for the contest... as will a lot of stuff I have been helped with lately on the forums. Thanks again Mark! Vernon "!" Zehr Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.