Tore Posted September 29, 2017 Share Posted September 29, 2017 (edited) - Edited April 19, 2018 by Tore Quote Link to comment Share on other sites More sharing options...
Fuchur Posted September 29, 2017 Share Posted September 29, 2017 Are there two planes meeting there / two full splines with connections running at the edge? If so, you need to delete one of them, and use the loose spline ends to connect the two ends. (click the left mouse button and drag the loose end cp to the other one and click with the right one (additional to the left one) if you are close enough. Best regards *Fuchur* Quote Link to comment Share on other sites More sharing options...
Tore Posted September 30, 2017 Author Share Posted September 30, 2017 (edited) . Edited April 19, 2018 by Tore Quote Link to comment Share on other sites More sharing options...
Fuchur Posted September 30, 2017 Share Posted September 30, 2017 Would be cool, but not to my knowledge... there is the connect plugin, but it does something a little bit different. Best regards *Fuchur* 1 Quote Link to comment Share on other sites More sharing options...
Hash Fellow robcat2075 Posted September 30, 2017 Hash Fellow Share Posted September 30, 2017 I suppose a wizard could be made but it would have to deal smartly with situations where the number of CPs on one side was not equal to the other side.Fortunately, we model with thin meshes in A:M so the labor of manually connecting surfaces is not onerous. 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.