fae_alba Posted March 24, 2017 Share Posted March 24, 2017 I'm experimenting with the bullet rigid body constraint. Nothing fancy, just a simple puzzle piece falling from the top of the chor to the ground plane, a bounce or three then stop. I intend on using this as part of a power point presentation I am putting together for work (the slide is "Pieces of the Puzzle"). What I am stymied on is keeping the puzzle pieces from penetrating the ground plane. I want the pieces to hit, bounce then wind up laying flat, but short of adjusting individual channels after the fact I don't see the magic setting to get that to happen. test.avi Project1.prj Link to comment Share on other sites More sharing options...
John Bigboote Posted March 24, 2017 Share Posted March 24, 2017 It looks like some are working- some not. I haven't played with Bullet- but usually you need to make sure your axis point is pretty centered on each puzzle piece. Also- are you working with a floor that has an increased mesh density? Link to comment Share on other sites More sharing options...
Admin Rodney Posted March 24, 2017 Admin Share Posted March 24, 2017 Yes, Matt's suggestion to create a denser ground plane should work. I took your project, added a 100x100 grid to the ground model (rotating it so that I could see it better), removed simulation data and then launched Bullet. Everything appears to work as required. Attached image is of final resting of puzzle pieces using your Project just with an additional grid added to the Ground model. Link to comment Share on other sites More sharing options...
Admin Rodney Posted March 24, 2017 Admin Share Posted March 24, 2017 Here's a run with the ground plane having a big hole pushed out of it (and using a hull). Lest you think I simulated with the characters present... I cheated. I simulated with cubes like the purple one in the shot and then swapped out their shortcuts for the characters. There were a few pass throughs of arms and such so I just rotated the models slightly to alleviate that. I added a tile image to the ground/grid to show the density I used... I don't think we need that dense a mesh but... that's what I used. Link to comment Share on other sites More sharing options...
fae_alba Posted March 24, 2017 Author Share Posted March 24, 2017 I did the same as Rodney with a denser grid and it simulated as I wanted. The pieces did a little mexican jumping bean routine at the end, but that was a simple enough fix of whacking the trailing keyframes. Link to comment Share on other sites More sharing options...
Jump to content
Recommended Posts