Defaults

[Simon Edmondson]

As explained elsewhere, I'm using V15 on an Imac running Snow Leopard to revisit an old project for a competion.

 

The original project was put together in V10 and, when complete, backed up onto CD's. They were originally done in 26fps because that is what I'm used to. And on a PC running Windows XP

 

I have had a few problems with V15 ( using the one off the CD) occassionaly dropping out and it seems to revert to its factory defaults each time it does it.

 

So, for example, I open it up to load the old project, having previously set the frame rate to 25fps. It imports the files but it imports them at 30fps, I reset the options under tools, save it and the project under a new name. When I went to render it dropped out. I reopened and carried on, only to have it default back to 30fps ( and some other settings too ). This is proving rather frustrating.

 

Is there a way to nail the default valus and havethem stay as set ? I have never encountered this before in earlier vrsions of the program...

Thanks in advance.

regards

simon

[largento]

Simon, have you tried changing the settings and then quitting A:M?

[Simon Edmondson]

Simon, have you tried changing the settings and then quitting A:M?

 

Before it quits on me ?

No I hadn't, but I will now.

thank you.

simon

[HomeSlice]

Simon, have you tried changing the settings and then quitting A:M?

Yes, that usually works in these types of situations.

[Simon Edmondson]

Simon, have you tried changing the settings and then quitting A:M?

Yes, that usually works in these types of situations.

 

 

I have done that and will check tomorrow to see if it worked. Its a good job my hair is already grey...

regards

simon