flashawd Posted August 26, 2009 Share Posted August 26, 2009 Hello - basic question, I think - I remember doing something like this a way back - but not sure how I did it. I have a "smoke" emitter in a chor. I turn it "on" at 3 seconds into the chor - and turn it "off" two seconds later - when I watch it in the timeline it works perfect - smoke comes in then fades out and disappears, but when I render it out, smoke comes in then abruptly stops when it hits the frame where I turned it "off". Am I doing something wrong, or is there a way to make it slowy turn "off" with a pose slider or something? Thanks for any help. ;-) Quote Link to comment Share on other sites More sharing options...
Hash Fellow robcat2075 Posted August 26, 2009 Hash Fellow Share Posted August 26, 2009 Are you animating the emitter rate in the Chor? Enable Show more than drivers. Quote Link to comment Share on other sites More sharing options...
flashawd Posted August 28, 2009 Author Share Posted August 28, 2009 Yes, that is what I was trying to do... I will do what you suggested. Thanks again. Quote Link to comment Share on other sites More sharing options...
flashawd Posted August 29, 2009 Author Share Posted August 29, 2009 Hey Rob - wanted to follow up - that worked perfect - just adjusted the emitters "life" in the chor timeline. Thanks again for all you help over the years. ;-) Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.