virus81 Posted February 1, 2008 Share Posted February 1, 2008 When I am using Wire frame mode of my model, edges of the model shown rounded (Please check the attached "Wireframe" pic). When I am using Shaded mode of my model, edges of the model shown sharp (Please check the attached "Shaded" pic). But I have seen from a tutorial that it does not happen with others. Just wondering if it is some set up problem. Can anyone please explain it to me? Quote Link to comment Share on other sites More sharing options...
Redoakville Posted February 1, 2008 Share Posted February 1, 2008 Hey Swtich to Shaded mode and then press "Page up" a few times. (Windows, not sure about Mac) "Page up" and "Page down" adjust that stuff....To say it quickly. Quote Link to comment Share on other sites More sharing options...
virus81 Posted February 1, 2008 Author Share Posted February 1, 2008 Thanks a lot! It worked. Quote Link to comment Share on other sites More sharing options...
Fuchur Posted February 1, 2008 Share Posted February 1, 2008 The backside of the coin: Your Graphic-card will have to work more. So if you feel that your system is slowing down, you should turn the subdivision-level down again (Page down)... It will anyway only effect the realtimeviews, not the final rendering. *Fuchur* Quote Link to comment Share on other sites More sharing options...
virus81 Posted February 3, 2008 Author Share Posted February 3, 2008 Thanks Fuchur. It's good to know Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.