*A:M User* Roger Posted July 5, 2011 *A:M User* Share Posted July 5, 2011 I know when you are pulling points you can constrain them to a specific axis, x, y or z but what I am curious to know is can you constrain a point along a single spline and adjust its position on that spline? Quote Link to comment Share on other sites More sharing options...
wildcard Posted July 5, 2011 Share Posted July 5, 2011 I know when you are pulling points you can constrain them to a specific axis, x, y or z but what I am curious to know is can you constrain a point along a single spline and adjust its position on that spline? Not sure if I fully understand your question. If you can move a CP around a spline with out altering the curve of the spline? Quote Link to comment Share on other sites More sharing options...
*A:M User* Roger Posted July 5, 2011 Author *A:M User* Share Posted July 5, 2011 Yes, that's more or less what I want to do. Probably not possible. Quote Link to comment Share on other sites More sharing options...
wildcard Posted July 5, 2011 Share Posted July 5, 2011 Yes, that's more or less what I want to do. Probably not possible. I don't believe this is possible, but I'm very new to AM myself so I might be wrong and I hope I am wrong for I like the idea of adding a CP to a spline and be able to move it along the spline with out altering it's curve. Quote Link to comment Share on other sites More sharing options...
itsjustme Posted July 5, 2011 Share Posted July 5, 2011 There is a list of hotkeys here...I believe what you're looking for are the 1-6 keys on the numpad. Hope that helps, Roger. Quote Link to comment Share on other sites More sharing options...
Fuchur Posted July 5, 2011 Share Posted July 5, 2011 Press "4" on the keys above the space-key (not sure how they are called... the non-keypad-keys). That should more or less do what you ask for... anyway it is not too useful... I recommend to you to use the stich-feature to stitch in a point where you want it to be. See you *Fuchur* Quote Link to comment Share on other sites More sharing options...
*A:M User* Roger Posted July 5, 2011 Author *A:M User* Share Posted July 5, 2011 Thanks Dave - that's what I was looking for. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.