Waldo3D Posted September 13, 2008 Share Posted September 13, 2008 On the Mac, it's the tilde(~) key. Maybe it's the same shortcut for the PC. Jim I know you can use the tilde-key to join splines or press the Left and the Right button on the mouse. But.. I'm on a Azerty-keyboard so there is no tilde-key AND I use the Mac with a mighty mouse. I can't press left and right at the same time. (if can I? ) PLUS I can't assign a shortcut since there is no Join or Spline join command? I search the forum but with no luck. What are my options here? Waldo Quote Link to comment Share on other sites More sharing options...
HomeSlice Posted September 13, 2008 Share Posted September 13, 2008 Try setting a keyboard shortcut for "Attach Control Point". Quote Link to comment Share on other sites More sharing options...
Waldo3D Posted September 14, 2008 Author Share Posted September 14, 2008 Try setting a keyboard shortcut for "Attach Control Point". Works! It was just knowing the right name of that command! Is there a way to set the prefs to an Azerty keyboard? Now A=Q Shift-Z to fit in view is Shift-W Or must I asign all shortcuts to my keyboard? Thx! Waldo Quote Link to comment Share on other sites More sharing options...
Fuchur Posted September 14, 2008 Share Posted September 14, 2008 You will have to do it by hand... I have a German keyboard (so z and y are changed) but I think this is something that isn't too bad. It's much worth that for example the slash isnt available that fast, etc. But in the end it is a change of 6 shortcuts or something like that... so there is no real need for a special threatment here. So I would suggested: Take the time (it cant be longer than 10 minutes) and change whatever you want. *Fuchur* Quote Link to comment Share on other sites More sharing options...
Waldo3D Posted September 14, 2008 Author Share Posted September 14, 2008 Thanks for all the fast responses! Waldo Quote Link to comment Share on other sites More sharing options...
Gerry Posted September 17, 2008 Share Posted September 17, 2008 Welcome to the Forum! Quote Link to comment Share on other sites More sharing options...
Waldo3D Posted September 18, 2008 Author Share Posted September 18, 2008 Nice to see an active forum! THX! Waldo Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.