tysono_71 Posted January 23, 2007 Share Posted January 23, 2007 Hello All, I am sorry is this was covered in another post, I just couldn't find it if there is one. I am going through David Rogers book A:M a Complete Guide. So far it's going well but I run into an issue and can't quite figure it out. I have attached a capture of the model that I am working on. This is a tutorial from the book. basicailly it's two cylinders one was lathed around the Y axes. The other needs to be lathed around the x axes. It's an exercise on changing the pivot point. I an unable to get it to pivot around the x axes. I have toyed with the properties in rotate mode but not sure which things to change. I'm sure it's something quite easy and probably starring me right in the face. Also are there tutorials on this subject? thanks a bunch, Tyson Quote Link to comment Share on other sites More sharing options...
Admin Rodney Posted January 23, 2007 Admin Share Posted January 23, 2007 You may find my Advanced Lathing Methodologies tutorial of interest. You have a few options when lathing of course but knowing that you can lathe anywhere in any axis... helps. Advanced Lathing Methodologies Its been so long since I looked at this tutorial I'm sure it could stand some updating. Perhaps someday... (Tutorial required Flash Player) Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.