jamagica Posted March 31, 2005 Share Posted March 31, 2005 I feel proud for what I've done (except the closest corner is uneven) Quote Link to comment Share on other sites More sharing options...
KenH Posted March 31, 2005 Share Posted March 31, 2005 Looks just like the one on the cd! Well done. Was there any technique you'd care to share? Quote Link to comment Share on other sites More sharing options...
jamagica Posted March 31, 2005 Author Share Posted March 31, 2005 nope! Just did it classical way...although you can mimic beveling by creating a peaked square with two points per corner as usual and then tweaking bias...then you extrude once and scale larger, then extrude all the way down for the sides..then extrude again scaling smaller, then close up the sides..only problem is that the bevel really only applies to half of the edges Quote Link to comment Share on other sites More sharing options...
iGeek Posted April 6, 2005 Share Posted April 6, 2005 If you select all and do Snap to Grid (the apostrophe key, I think...), it'll snap if you modeled to a grid. Then just reset all the biases and you're good to go. I modeled a beveled wrapped present. boy, was that not fun. It was like a cube but with an inside that had to all line up. -Zev Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.