Smoke slowly fade out

[flashawd]

Hello - basic question, I think - I remember doing something like this a way back - but not sure how I did it. I have a "smoke" emitter in a chor. I turn it "on" at 3 seconds into the chor - and turn it "off" two seconds later - when I watch it in the timeline it works perfect - smoke comes in then fades out and disappears, but when I render it out, smoke comes in then abruptly stops when it hits the frame where I turned it "off". Am I doing something wrong, or is there a way to make it slowy turn "off" with a pose slider or something? Thanks for any help. ;-)

[robcat2075]

Are you animating the emitter rate in the Chor? Enable Show more than drivers.

[flashawd]

Yes, that is what I was trying to do... I will do what you suggested. Thanks again.

[flashawd]

Hey Rob - wanted to follow up - that worked perfect - just adjusted the emitters "life" in the chor timeline. Thanks again for all you help over the years. ;-)