wwoelbel Posted February 8, 2005 Posted February 8, 2005 This is a birds-eye of the full column segment. Just for reference Quote
wwoelbel Posted February 8, 2005 Author Posted February 8, 2005 This one is a top view in wire frame of the full column segment superimposed over the 1/2 segment. As you can see, The smaller square in the center is the bottom of the expanding region and will sit on a column. The line to the left of the center square is the left edge of the 1/2 version. I took a copy of the full segment and translated the left edge over until it was directly above the center piece. The problem comes in the next image. Quote
wwoelbel Posted February 8, 2005 Author Posted February 8, 2005 This one shows the point of my concern. On the rightside is where I have re-adjusted the bias by hand. On the left is the unadjusted version. I do realise that I will need to put a bevel on the lip edges or they will never lineup (RR is right. close is good but I would like to be "closer"). Bill Quote
wwoelbel Posted February 9, 2005 Author Posted February 9, 2005 The project file if your curious. columns.prj Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.