gra4mac Posted October 5, 2003 Share Posted October 5, 2003 I was trying to make cloth look like water. I've seen worse, better too. http://www3.telus.net/imagestreamstudio/te...l_wake(on2).mov Quote Link to comment Share on other sites More sharing options...
Grubber Posted October 5, 2003 Share Posted October 5, 2003 hmm... interesting... very interesting... ...and curious... how to make such with v9.5? Quote Link to comment Share on other sites More sharing options...
gra4mac Posted October 5, 2003 Author Share Posted October 5, 2003 I did the cloth water in 10.5, but I think it works the same in 9.5. Make a grid, I used 60x60 with 5 cm spacing. Group the inner CPs for the cloth, leave the outer row of cps to anchour the cloth. In the CHO/muscle mode, select the cloth CPs and control click, for Macs, Cloth Wizard. I leave the cloth settings at the defaults: I don't see any difference with changing them anyhow, but in the CHO properties/dynamics, set the y value to "0" so there is no gravity. Start the ball above the cloth and lower about 1/2 way, to give the cloth time to react and move out of the ball's way. Then move the ball along the cloth. Now run the Spring simulation. Quote Link to comment Share on other sites More sharing options...
gra4mac Posted October 5, 2003 Author Share Posted October 5, 2003 I added a version with the ball dropping straight through the cloth. http://www3.telus.net/imagestreamstudio/te...p_cloth_on2.mov Quote Link to comment Share on other sites More sharing options...
xor Posted October 5, 2003 Share Posted October 5, 2003 Those are awesome. I can just imagine what all you could do with these and other variations. Good Work. Lance Quote Link to comment Share on other sites More sharing options...
Grubber Posted October 6, 2003 Share Posted October 6, 2003 Thank you Graham! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.