Ben28 Posted March 3, 2009 Posted March 3, 2009 So I'm working through the flower tutorial. After drawing my line with 7 control points, and clicking the lathe, I wanted to adjust them. Every time I try to group a line of cp's it's always leaving one or two control points out. and therefor cause my stem to disform. Does anyone know what I can do about this so it'll change the way it groups? Quote
Ben28 Posted March 3, 2009 Author Posted March 3, 2009 I just tried to click on one of the control points, and pushed the forward slash key on my keyboard and it still didn't group the whole stem. I'm wondering if I have need to go into the properties and the default is not set. So so frustrating. I can't go on, because I can't even move the whole stem. Grrrr. Any help would be greatly appreciated! Quote
HomeSlice Posted March 3, 2009 Posted March 3, 2009 Make sure "Mirror Mode" is OFF. When you select a control point and hit the [/] key, all control points that are connected to the one you selected will be included in the selection ... except if you have mirror mode on. Quote
Ben28 Posted March 3, 2009 Author Posted March 3, 2009 You Gentlemen are so wonderful. Thank you so much. Sorry for such a dumb question. I know that you guys probably get these questions a zillion time. But that's for helping me out. I love this community! Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.