Stronghorn Posted February 9, 2008 Posted February 9, 2008 When I select mirror mode, it does not mirror oppisite side. Is there another setting I need to adjust? I am running V15a. Quote
Fishman Posted February 9, 2008 Posted February 9, 2008 There are two ways to interpret your question. If you have made half a model and are trying to mirror it to make a whole model, then you are in need of Copy Flip Attach. If you have a whole model and want to move control points on either side of the center line by moving CP's on one side then it is mirror mode that you want. If so, then the CP's need to be in the same spot on either side of the symmetry line within a certain tolerance. I believe that tolerance is set in Options. Hope that helps a little. Scott Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.