Jump to content
Hash, Inc. Forums

Looking for help w 5 point patches


Recommended Posts

I have tried deleting splines & re-adding them. This has solved a couple of the problem spots where I cannot make a 5 point patch. The others are stubborn...could I have some duplicate control points or something - if so how would I find them? Also, on four 5 point patches there are squiggly line artifacts even with porcelain. again - none of my attempts to fix have worked. Any suggestions?

Problem_Shell.zip

Link to comment
Share on other sites

I needed to add more holes - so I re did the whole thing being VERY CAREFUL not to have 2 control points in the same location, Etc. Got the Outer layer perfect - great. Copied it - great - resized and flipped normal to make cylinder liner - closed up seams around holes - great. then normals started flipping and now I have 2 outer 5 pointers that just wont close up....damn. Is there anything different in Ver 1`5 from Ver 13 about 5 pointers? I never had so many headaches with them.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...