Jump to content
Hash, Inc. Forums

Replacing a model in a Chor


flashawd

Recommended Posts

Hello - it's been a few weeks, been working on another tooth animation - hope everyone is doing good. Have a small issue I have a model in a chor and had to make some changes to it, but wasn't sure if the changes were going to work - so I renamed it so I wouldn't effect the original if it didn't come out right. The original is in the chor as "impression2" - the one I want to use is called "impressionFinal". Is it possible to point it to that, so I don't have to go in and redue that portion of the chor? Thanks - Eric

Link to comment
Share on other sites

Assuming you haven't changed the rig or number of cps, it should work flawlessly.....

 

In the shortcut to the old model in the chor go to the properties window. If you have the new model in the project, you'll be able to select it from the list.

swap.jpg

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...