Leaderboard

well it's taken a bit, but this project is ready for paint. Some stats: Papa Bear stands 4.15 inches tall. The base is 5.5 inches long. There are 5 separate prints done; Papa Bear, his fishing pole, the base, and the fins of the fish. All were modeled in A:M, exported at 64 subd. Printed under a normal setting with 100% infill (the fishing rod and fish fins) to 20% infill (papa bear and the base). The fish in the base is a perfect example of being able to print merged models. The fish is a separate model which I placed in a chor with the base, scaled down, then simply set inside the base and posed. The slicing software (CURA) had no problem with it. The fins I had to model and print separately since they were simply too fine and at a bad position for 3d printing. Once printed it took some cleanup. Heavy sanding to get the support ridges smoothed out, then I hit Papa Bear with two coats of model filler to hide much of the layering. Sanded, then painted with a car body primer filler spray paint. Now I will paint with some Testors Model Paint, then a clear coat. Then Papa Bear will take his place on the shelf of glory in my office!